reportstotal.blogg.se - Fs lite trainer ii

unless on OpenTX 2.3.3+ you use the "Disable channel mapping" feature on the GUI. RX output will match the Hype standard AETR independently of the input configuration AETR, RETA. Surface protocol called FHSS introduced in 2017.

Once activated, any bind will only happen if all these elements are happening at the same time:.

Bind on channel can be locally enabled/disabled by setting "Bind on channel" or "Autobind" per model for serial or per dial switch number for ppm.

Any channel between 5 and 16 can be used by configuring BIND_CH in _config.h.

Bind on channel can be globally enabled/disabled in _config.h using ENABLE_BIND_CH.

In case a protocol is not autobind but you want to enable it, change the "Autobind" or "Bind on channel" on OpenTX setting to Y for the specific model/entry. In these protocols you do not need to press the bind button at power up to bind, it will be done automatically. This is for models where the receiver expects to rebind every time it is powered up.

Autobind protocol - The transmitter will automatically initiate a bind sequence on power up or model/protocol selection.

Italic numbers are referring to protocol/sub_protocol numbers that you should use if the radio (serial mode only) is not displaying (yet) the protocol you want to access.

Otherwise it will be truncated to -100%.+100%.

Extended limits supported - A channel range of -125%.+125% will be transmitted.

Channel ranges - A radio output of -100%.0%.+100% will match on the selected protocol -100%,0%,+100%.

The module will take whatever input channel order you have choosen and will rearrange them to match the output channel order required by the selected protocol. You can change this in the compilation settings or by using a precompiled firmware.

Channel Order - The channel order assumed in all the documentation is AETR.

The Deviation project (on which this project was based) have a useful list of models and protocols here. If you want to see examples of model configurations see the Models page. Here are detailed descriptions of every supported protocols (sorted by RF modules) as well as the available options for each protocol.